Xblue Networks X-50 Installation Manual page 195

FXO (Telephone (Trunk) Line)
Call Abandon Time - This is the timer that the system uses to verify the At default the call abandon timer
•
is set to 600 ms, and is adjustable from - Disabled, and 100 to 1000 ms. Changing this may cause erratic
operation.
Ring Recognition Time - This timer determines the minimum ring signal detection time for all analog
•
telephone lines. Changing this may cause erratic operation.
Delay Ring Time - This timer determines the amount of time that the system will wait before the system
•
begins audibly ringing. Changing this may cause erratic operation.
Dial Wait Time - This parameter is to compensate for older telephone line providers, which are slow to
•
process the first digit dialed. Changing this parameter may cause erratic operation.
Interdigit Timeout - This timer is the amount of time that will be allowed to pass between digits dialed.
•
Flash Time - This timer determines the flash timing that will be sent to the telephone line provider when
•
the user presses the hook-switch.
Flash New Call - Enable/Disable - This allows the administrator to grant or deny system users the ability
•
to flash the telephone line to "renew" dial tone and allow the caller to start dialing. Disabling this feature
will disable call waiting.
FXO to FXO Call Duration - This time establishes the amount of time two telephone lines can be
•
conferenced together before the call is disconnected. The default is 5 minutes, and is adjustable from 1
to 15 minutes plus unlimited. Note: It is not advised or recommened to set this timer to "unlimited".
DTMF Signal on Duration - This is the amount of time that the DTMF tone will audibly play.
•
DTMF Signal off Duration - The is the amount of time that will pass between between audible tones.
•
Pause Time - The pause timer, which appears as a "P" is the amount of time that will pass between
•
dialing functions.
Ring Abandon Time - This timer gives the system the ability to match a telephone line provides'
•
disconnect timer.
Release Guard Time - This timer is a noise sensitivity adjustment timer used to eliminate false
•
disconnects. At default it is set to 1.0 and can be set from 1.0, 1.5, 2.0, 2.5, 3.0. Increase this timer to
ignor noise on the telephone lines to avoid erroneous disconnects.
XBLUE Networks
Voice
197