Xblue Networks X-50 Installation Manual page 89

Wireless Basics
The X-50 is equipped with a wireless router, which allows wireless devices to connect using 802.11b, 802.11g and
802.11n protocol speeds.
• Enable Wireless - The wireless router is enabled at default, and can be disabled by un-checking this
parameter.
•
Hide Access Point - Check this parameter to "hide" the X-50 wireless signal. This stops the SSID from
being broadcast, making it harder for unauthorized endpoints to access the Wireless Access Point
(WAP). When SSID is disabled, the uer must enter the specific IP Address of the X-50 to connected
wirelessly.
• SSID - Service Set IDentifier - This is the name that will be broadcast to make it easier for authorized
endpoints to connect to the X-50 wirelessly.
•
BSSID - Basic Service Set IDentifier - uniquely identifies each Basic Service Set (BSS), which is the
building block for all 802.11(x) devices. The BSSID is a locally administered MAC Address of the
Wireless Access Point (WAP).
•
The Country parameter determines the frequencies and restricts based on country requirements.
XBLUE Networks
Programming Wizard
89