Video Suggestions And Tips; Failsafe Function; When Will Failsafe Activate; Failsafe Procedure - dji PHANTOM 2 VISION+ User Manual

When the Rear LED Flight Indicator blinks yellow rapidly during light, the aircraft has entered Failsafe mode.
Refer to Failsafe Function(Page 27) for details.
A low battery level warning is indicated by the Rear LED Flight Indicator blinking red slowly or rapidly during
light. Refer to the Low Battery Level Warning Function(Page 28) for details.
View tutorials about light for more light information:www.dji.com/phantom2visionplus/training.
Aircraft and battery performance is subject to environmental factors such as air density and temperature. Be
very careful when lying 3000 meters (9800 feet) or more above sea level, as battery and aircraft performance
may be reduced.

3.2 Video Suggestions and Tips

(1) Work through the check list before each light.
(2) Set the gimbal working mode to Stabilized.
(3) Aim to shoot when lying in Ready to Fly only.
(4) Always ly in good weather, such as sunny or windless days.
(5) Change camera settings to suit you. These include FOV, photo format and exposure compensation.
(6) Take light tests to establish light routes and scenes.
(7) Push the sticks gently to make aircraft movements stable and smooth.

4 Failsafe Function

The Phantom will enter Failsafe mode when its connection to the Remote Controller is lost. The Flight Control System will
automatically control the aircraft to return to home and land to prevent injury or damage.
Home Point: When the Phantom enters 'Ready to Fly' from the 'Ready to Fly status (non-GPS)', the GPS
coordinates will be recorded and set as the home point.
When Remote Controller signal is lost, the aircraft will return to the recorded home point coordinates and land.
Home point coordinates are used to calculate the horizontal distance of the aircraft (shown as "Distance" on the
GUI of the DJI VISION App).
After successfully record the home point, rear LED light indicators blink fast green.
Dynamic Home Point: The Home point will be reset to position of the mobile device at speciic time intervals.
Enable dynamic home point in DJI Vision app or Phantom 2 Assistant.
Dynamic home point is only available to the GPS-enabled mobile device. Turn on GPS and data service to
obtain higher accuracy of the mobile device position.
Dynamic home point is useful in situations when you are in motion and require a Home point that is different
from the takeoff point.

4.1 When Will Failsafe Activate?

(1) The Remote Controller is powered off.
(2) The Phantom has lown out of effective remote controller range.
(3) The signal between the Remote Controller and the Phantom has been blocked.
(4) There is interference causing a signal problem with the Remote Controller.

4.2 Failsafe Procedure

Initiating the Failsafe mode from different lying statuses will results in different landing processes.
Ready to Fly(non-GPS)- Automatic landing
The Flight Control System will keep the aircraft level during descent and landing. It may be drift during the descent and landing process.
Ready to Fly- Automatic go home and land
The Flight Control System will automatically control the aircraft to ly back to the home point and land.
1 Record Home Point
LED Flight Indicator
Yellow lashing Green lashing
4 Signal lost lasts 3s, begin to go home
LED Flight Indicator Yellow lashing
2 Flying
LED Flight Indicator Green lashing
5 Fly back to home point
Height over home point>20m
Elevate to 20m
20m
Height over home point<=20m
LED Flight Indicator Yellow lashing
Figure 52
3 Remote Controller signal lost
LED Flight Indicator Yellow lashing
6 Landing after hovering 15s
LED Flight Indicator Yellow lashing
©
2015 DJI. All Rights Reserved.
Flight
27