Usages - dji PHANTOM 2 VISION+ User Manual

Assembly and Use
DJI Smart Flight Battery Functions
(1) Balance Charging
(2) Capacity Display
(3) Communication
(4) Overcharge Protection
(5) Over Discharge Protection
(6) Short Circuit Protection
(7) Sleep Protection
(8) Charging Temperature Detection The battery will charge only when the temperature is between 0℃ (32°F) and
Battery Speciications
Type
Capacity
Charging Environment Temperature
Discharging Environment Temperature
Charging/Discharging Environment Relative Humidity
Please read the user manual, disclaimer, and battery warnings before use. Users take full responsibility for all
operations and usage.

2.2 Usages

Powering on/off
Powering on: Press Circular Power Button once, then press again and hold for 2 seconds to power on. Power Light will
go red and Battery Level Indicators will show the current battery level.
Powering off: Press Circular Power Button once, then press again and hold for 2 seconds to turn off. Battery Level
Indicators will all go out.
Checking the battery level
When the battery is powered off, press the Circular Power Button once. Battery Level Indicators will light up to show
battery level. See below for details.
Battery Level Indicators will show the current battery level during charging and discharging. The indicators are
deined below.
LED is on
LED is off
8
©
2015 DJI. All Rights Reserved.
Automatically balances the voltage of each battery cell during charging.
Displays current battery levels.
Communicates with Flight Controller about battery voltage, capacity, current and
other relevant information.
Charging stops automatically when battery voltage reaches 12.8V to prevent
overcharge damage.
Discharging stops automatically when battery voltage reaches 8.4V to prevent
over discharge damage.
Automatically cuts power supply when a short circuit is detected.
Sleep mode is entered after 10 minutes of inactivity to save power.
40℃ (104°F).
Figure 5
LED blinks
LiPo
11.1V, 5200mAh
0°C~40°C
- 20°C~50°C
<80%
LED1
LED2
LED3
LED4
Circular Power Button
(Built-in Power Light)
Battery Level Indicators