Remote Surveillance; Ie Remote Surveillance By Nat; Nat Settings; Nat Access - Provision ISR IPSeries User Manual

8
Remote Surveillance
8.1 IE Remote Surveillance by NAT
8.1.1 NAT Settings
①
The DVR shall be powered on and connected to the network.
②
Go to Main MenuSetupNetworkNetwork. You can obtain the IP address, Subnet
Mask and Gateway automatically. You can also manually input them according to the
actual network situation. And the IP address shall be in the same network segment as
the network which is used.
③
Set the preferred or alternative DNS Server (Please refer to 4.6.1 Network for details).
④
Go to Main MenuSetupNetworkNAT tab.
⑤
Enable NAT and input the NAT Server (The default NAT Server is www.provisionisr‐nat.com).
⑥
Click "Apply" to save the parameters (Please refer to 4.6.5 NAT for details).
8.1.2 NAT Access
After finishing the NAT settings, you can enter the NAT Server on the PC (Input
http://www.provisionisr‐cloud.com to go to the IE client). If you are the first time to access the
NAT, the network will download the ActiveX automatically.
Note: If you cannot download and install ActiveX, please refer to FAQ Q7.
After installing ActiveX successfully, it will pop up the login box:
Serial No: The MAC address of the DVR (Go to Main MenuInformationQRCODE to check
the number below the QR code).
User Name: The login username of DVR. The default username is admin.
Password: The login password of DVR. The default password is 123456.
AHD DVR User Manual
47