Nat; Other Settings - Provision ISR IPSeries User Manual

③
Enable the auto report in the ECMS/NVMS when adding a new device. Then input the
remaining information of the device in the ECMS/NVMS and self‐define a device ID.
④
Input the above‐mentioned server IP, server port and device ID in the server interface.
Then click "Apply" button to save the setting. Now, the ECMS/NVMS system will
automatically connect this device.
5.6.5 NAT
①
Go to Main MenuSetupNetworkNAT interface. Refer to Fig 4‐27.
②
Enable NAT and input the NAT Server (The default NAT Server is www.provisionisr‐nat.com
and the default port is 8989
③
Click "Apply" to save the settings.
5.6.6 Other Settings
If your DVR is set to use PPPoE as its default network connection, you may set up DDNS to be
used in connection. The setting steps are as follows:
①
Enable and select DDNS server.
②
Enter user name, password and host domain name of the registered website.
③
Click "Test" button to test the effectiveness of the relevant information.
④
Click "Apply" button to save the setting.
AHD DVR User Manual
Fig 4‐27 Network Configuration‐NAT
.
)
30