Connecting A Pc - Nikon Eclipse LV100DA-U Instructions Manual

14

Connecting a PC

To use this product, connect a PC after assembling this product and perform the setup works
(various settings) for the microscope system with the setup software, "LVSetup."
Use the universal serial bus (USB) interface to connect with the PC. After assembling and
connecting the microscope, connect the USB cable between the PC and the microscope and perform
the setup works for the microscope.
The USB connector of this microscope is located in the connector panel on the side.
For details about the operation and the setup works of the "LVSetup," refer to the "LV Series
Support Tools software manual."
Connecting with a PC when using the "NIS-Elements"
Motorized units can be controlled on a PC with "NIS-Elements," the software for digital
cameras, when a digital camera is used with the product. To use the NIS-Elements, connect
the product and the PC with the USB interface in the same manner described above.
96
P
F.S TO
BF DF FL1 FL2
FL1 FL2
UEP I2A
USB
RS2 32C
LCN T
0.8
0.7 Achr N.A
0.6 0.5 0.4 = 0.9 JAPAN
0.3 0.2 0.1
NCB
ND8
F.S.
USB cable
PC