Microscopy Method - Nikon Eclipse LV100DA-U Instructions Manual

Microscopy Method

CAUTION
Before performing microscopy
• Before using the microscope, please set up the LV100DA-U using "LVSetup" on a
PC contained in "LV Series Support Tools."
• In this chapter, the microscopy is described with the interlock control of LVSetup
set to the Default mode. When the interlock control mode is set to the Optional
mode, the microscope may behave differently from the ways that are described in
this chapter.
• The interlock control of each electrically-driven device can be enabled using
LVSetup. When this function is enabled, the corresponding electrical devices are set
to the predetermined conditions in accordance with the microscopy method or
objective. If the interlock control is disabled, please be sure to operate each device
manually.
• For operations of LVSetup, see "LV Series Setup Tools Software Manual."
• Motorized units can be controlled on a PC with "NIS-Elements," the software for
digital cameras, when a digital camera is used with the product. For details, see the
instruction manual for the "NIS-Elements."
This chapter explains the procedure of each microscopy.
• See "IV. Assembly," when the microscope has not been assembled yet.
• For detailed information about operations of parts of the microscope, refer to "III. Operation of
Each Part."
13