Installing The Lamphouse; Connecting The Power Supply - Nikon T1-FM Instructions Manual

Installing the lamphouse

6
(1) Aligning the pin on the lamphouse with the
groove in the epi-fluorescence attachment,
push the lamphouse into the epi-fluorescence
attachment main body as far as it will go.
(2) Tighten the two lamphouse clamp screws using
the supplied hexagonal wrench.
7

Connecting the power supply

(1) Check the voltage display on the power supply
rear panel. If the display differs from your local
voltage, change the display as follows. (Fuse
replacement can also be performed as part of
this procedure.)
1) Using the tip of a flat-head screwdriver, press the
fuse holder stoppers
the arrow and remove the fuse holder.
2) Using the tip of a flat-head screwdriver, press the
fuse holder stoppers
the arrow and remove the fuse holder.
3) Pull the voltage switcher out of the fuse holder
once. Replace the switcher into the fuse holder so
as to display the same voltage as the local voltage
being used in the window.
4) Check that two fuses are installed and return the
fuse holder to the original position.
(2) Slide the frequency changeover switch on the
power supply rear panel to the frequency
position to be used. An incorrect setting may
damage internal circuitry, resulting in risk of an
accident.
(3) Turn OFF the power switch.
(4) Plug the lamp input connector into the OUTPUT
connector on the power supply rear panel and
secure by tightening the lock ring.
(5) Plug the supplied power cord into the AC IN
socket on the power supply rear pane.
(6) Plug the power cord plug into an AC electrical outlet.
V Assembly
6 Installing the lamphouse
and in the direction of
and in the direction of
E-24
Hexagonal
Epi-fluorescence
wrench
attachment groove
Lamphouse pin
60Hz
50Hz
Frequency changeover switch
Fuses Voltage switcher
Voltage display
OUTPUT
connector
AC IN socket
Power cord
Lamphouse
clamp screws
Fuse holder
Voltage display
Window
Fuse holder
Lamp input
connector