Table of Contents
Advertisement
Power supply of the external power supply
When the lamp house is connected to the external power supply (TE2-PS100W), please turn on the
power as follows.
1 Check that the lamp house has been properly
connected to the external power supply.
(See Page 88.)
2 Verify that the EXTERNAL switch on the back of
the power supply has been set to the ON side.
3 Turn the power switch on the front of the external
power source to the " I " side to turn on the power
source.
Be sure to turn on the power supply first, and then
turn on the product.
4 Turn on the product.
Power supply of the external light source
When the external light source (Intensilight C-HGFIE or EXFO X-Cite 120 PC) is used, follow the
procedure below to turn on the power.
1 Verify that the product has been properly connected to
the external light source.
(See Pages 89 and 90.)
2 Turn the power switch on the front of the light source
to the " I " side to turn on the light source.
Be sure to turn on the light source first. And then turn
on the product.
• Intensilight C-HGFIE: When the product is turned
on, the POWER indicator lights up and the LAMP
indicator blinks. When the product starts normally,
the LAMP indicator lights up.
• EXFO X-Cite 120 PC: When the operation is
turned on, the back light of the LCD blinks. When
the operation starts normally, the back light of the
LCD lights up.
The external light source cannot receive any communication command until starting up
normally. Therefore, if the product is turned on during the initialization of the external
light source, the external light source will not be detected by the product. Be sure to wait
until the external light source starts up.
3 Turn on the product.
• It will take a few minutes for the external light source to become the ready condition. The
product must be turned on after making sure that the external light source starts normally.
• To use the external light source, carefully read the instruction manual and make sure to
follow the instructions.
III. Operation of Each Part
POWER
Power
switch
MIN.
MAX.
TE2-PS100W front
EXTERNAL switch
MODEL TE2-PS100W
MADE IN JAPAN
ON
E
X
T
E
R
N
A
L
OFF
TE2-PS100W rear
INTENSILIGHT
C-HGFIE
LAMP indicator
LAMP
POWER
indicator
RUN T IME hrs.
POWER
Power switch
Intensilight C-HGFIE
front view
35
Hide quick links:
Advertisement
Table of Contents
