Appendix; Moving The Ultimail To Another Location - FP ultimail Operator's Manual

Moving the ultimail to another location

Warning! Switch off the ultimail and all connected equipment prior to
dismantling and transporting the franking system.
Make sure that no liquids or foreign objects penetrate the interior of the
ultimail. If this happens, pull out the power plug immediately. Have the ultimail
franking system checked by Francotyp-Postalia service before starting it up
again.
Caution! Observe the following notes for preventing damage on the ultimail:
• Fully empty the water tank and water tray before transporting feeders or
sealers.
• Never transport the components holding at attachments, such as label
dispenser, weighing platform, adjustable letter guide, etc.
• Hold the individual components by the bottom part of the housing.
• Always move the franking system in a horizontal position.
• Once you have set the franking system from a cold environment to the new
location: Wait for two hours at least before starting up the ultimail once
again. The ultimail adapts to room temperature. Any condensation
evaporates.
• We recommend using the original packaging if you wish to move the
ultimail or send it to the Francotyp-Postalia service.
This chapter describes how to dismantle and install the ultimail including its
optional components. If some of the measures do not apply to your configu-
ration, just continue with the next step.
Appendix – Moving the ultimail to another location

Appendix

183