FP ultimail Operator's Manual page 159

Pin (rear)
Pin (front)
• Clean brush or replace with a new one.
• Moisten a new brush before inserting it.
• Hold the brush as shown in the figure.
The bristles must face down.
• Put the rear pin into the clip of the
sword as indicated by the arrow.
• Then carefully snap the front pin into
the clip of the sword.
• Push the roller transport down until it
locks into place.
• Attach the feeder / sealer to the
franking machine.
For details on attaching the feeder /
sealer to the franking system, read pages
188 to 190.
Maintenance and care
159