FP ultimail Operator's Manual page 168

168
ultimail Operator Manual
Problem
...
with envelope sealing (feeder / sealer ultimail)
Letters are not sealed.
Letters are not correctly
sealed.
ultimail does not start
when you have positioned
mail pieces.
Possible cause and remedy
Seal envelope is switched off.
Switch on seal envelope (see page 41).
Water tank is empty.
Fill the water tank (see chapter 14.6).
Use 'sealit' sealing liquid, available from Francotyp-
Postalia.
Rub powerfully with your hand over the letter stack
once in the area of the flaps.
Moistening sponge and brush are dried because the
water tank was empty over a longer period of time.
Remove sponge and let it soak up completely
(see chapter 14.8).
Sponge is dirty.
Clean the sponge (see chapter 14.8).
Sponge is worn.
Exchange the sponge (see chapter 14.8).
You have used unsuited envelopes. Observe
specifications (see page 200).
Entry sensor does not recognise the letters.
Start letter transport with Start/Stop key.