Table of Contents
Advertisement
I
2.1
GENERAL
SECTION 2
INSTALLATIO-N
This section explains how to install
t~e
monitor and how
to verify its basic operation.
Like most commercial TV
receivers,
~~e
monitor is
~~oroughly
adjusted and checked
out at the factory, but i t may require certain minor
adjustments to adapt i t to a particular display generator
or other controller and to compensate for minor
adjus~~ent
disturbances caused during shipment.
For convenient
reference, complete adjustment procedures and
o~~er
basic
checks are consolidated in Section 3, but only selected,
simple procedures should be necessary for initial instal-
lation.
2 • 2
UNP ACKING
The monitor is normally packaged in a separate shipping
container unless i t is incorporated into a system by
MITSUBISHI
ELECTRIC
CORPORATION.
Carefully open t..."1.e top
of the container.
Remove the inside packing material and
lift out t..."1.e monitor.
2 • 3
AS SEMBLY
The monitor is supplied completely
assa~led.
2.4
CAUTION BEFORE "POWER ON"
Please make sure that PCBs, wires, components and struc-
tures are in perfect mechanical order
~~d
not damaged
during transportation.
Particular attention should be paid to the anode cap of
t...~e
CRT and to ensure t..."1.at
t...~e
sync select switch (S301,
302) on PCB VIDEO is set
accordL~g
to the input
si~nal
(WS or WO, COMPOSITE or HD/VD) .
2-1
;:-
Advertisement
Table of Contents
