Audio Control; Commands From External Control To - Shure DCS 6000 User Manual

DIS Digital Conference System
10.3

Audio Control

10.3.1 Commands from External Control to CU 6110
10.3.1.1 Set loudspeaker volume
Set the volume of loudspeakers for all Conference units.
loudspeaker_volume <volume><CR>
<volume> The volume of the loudspeakers ranging from -41 to 0. The value -41 indicates Off, whereas values from -
40 to 0 indicates attenuation in dB.
The CU responds to this command by returning a 'loudspeaker_volume' command.
10.3.1.2 Set line input 1 level
Adjust the level of line input signal.
line_input_level_1 <level><CR>
<level> The level of line input 1 ranges from -41 to 0. The value -41 indicates Off, whereas values from -40 to 0
indicates attenuation in dB.
The CU responds to this command by returning a 'line_input_level_1' command.
10.3.1.3 Set line input 2 level
Adjust the level of line input signal.
line_input_level_2 <level><CR>
<level> The level of line input 2 ranges from -41 to 0. The value -41 indicates Off, whereas values from -40 to 0
indicates attenuation in dB.
The CU responds to this command by returning a 'line_input_level_2' command.
10.3.1.4 Set line input 1 gain
Adjust input gain of the line in 1 input.
line_input_gain_1 <gain><CR>
<gain>: 0 or 10
Gain can be set to 0 dB or 10 dB. 0 dB will not add any gain to the line input whereas 10 dB will add 10 dB gain to the
line input.
The CU responds to this command by a line_input_gain_1 message.
10.3.1.5 Set line input 2 gain
Adjust input gain of the line in 2 input.
line_input_gain_2 <gain><CR>
<gain>: 0 or 10
Gain can be set to 0 dB or 10 dB. 0 dB will not add any gain to the line input whereas 10 dB will add 10 dB gain to the
line input.
The CU responds to this command by a line_input_gain_2 message.
User Manual CU 6110 rev A.docx
User Manual
61