Fcc Rf Exposure Information - Docomo Arrows NX F-06E Instruction Manual

*** Tests for SAR have been conducted using standard
operation positions with the phone transmitting at its
highest certified power level in all tested frequency
bands. Although the SAR is determined at the highest
certified power level, the actual SAR level of the phone
while operating can be well below the maximum value.
This is because the phone is designed to operate at
multiple power levels so as to use only the power
required to reach the network. In general, the closer you
are to a base station antenna, the lower the power output.
Federal Communications Commission
(FCC) Notice
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions :
a this device may not cause harmful interference, and
b this device must accept any interference received,
including interference that may cause undesired
operation.
Changes or modifications made in or to the radio phone, not
expressly approved by the manufacturer, will void the user's
authority to operate the equipment.
The device complies with 15.205 of the FCC Rules.

FCC RF Exposure Information

This model phone meets the U.S. Government's requirements
for exposure to radio waves.
This model phone contains a radio transmitter and receiver.
This model phone is designed and manufactured not to
exceed the emission limits for exposure to radio frequency
(RF) energy as set by the FCC of the U.S. Government. These
limits are part of comprehensive guidelines and establish
permitted levels of RF energy for the general population. The
guidelines are based on standards that were developed by
independent scientific organizations through periodic and
thorough evaluation of scientific studies.
The exposure standard for wireless mobile phones employs a
unit of measurement known as the Specific Absorption Rate
(SAR). The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR
are conducted using standard operating positions as accepted
by the FCC with the phone transmitting at its highest certified
power level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual SAR
level of the phone while operating can be well below the
maximum value. This is because the phone is designed to
operate at multiple power levels so as to use only the power
required to reach the network. In general, the closer you are to
a wireless base station antenna, the lower the power output
level of the phone.
Before a phone model is available for sale to the public, it must
be tested and certified to prove to the FCC that it does not
exceed the limit established by the U.S. government-adopted
requirement for safe exposure. The tests are performed on
position and locations (for example, at the ear and worn on the
body) as required by FCC for each model. The highest SAR
value for this model phone as reported to the FCC, when tested
for use at the ear, is 0.72W/kg, and when worn on the body, is
190
Appendix/Index