Table of Contents
Advertisement
noTE
If the dish is pointed towards an incorrect satellite or if there is no signal or the signal from the satellite
dish is too low, the receiver cannot install channels and will go to the Main Menu. Please, first check the
cables, the alignment of the dish and the settings and try to setup again.
5.0 QUICk GUIDE To UsInG YoUR RECEIvER
We at STRONG understand that you can't wait to enjoy your new HD receiver. The following quick
guide will make you familiar with the basic operation of this device. We do, however, advice you to
read the full manual on our website: www.strong.tv/downloads/manuals/7504_UM_EN.pdf. to get the
best performance from your STRONG HD receiver.To switch your receiver ON or to Standby, use the q
button on the remote control or the button on the left side of the front panel.Please insert your valid
and activated Irdeto smart card for proper reception of the channel bouquet of your choice. For correct
insertion of the smart card please see the insertion drawing (fig.?).Choose a channel with pq or the
Ch+/Ch- buttons. Alternatively, you can digit the channel number with the 0~9 buttons on the remote
control or press ok in viewing mode to display the channel list.The volume can be adjusted with the
voL+/voL- buttons. The usage of voL+/voL- and ! is possible in ALL menus which present a TV
picture in the background and can additionally be used in the videotext mode. In viewing mode you
can also use tu.P+/P- enable you to scroll pagewise in all list modes to make your channel selection or
another selection as comfortable as possible.
noTE
6.0 oPERATIon
In viewing mode, several features are available to make watching TV a true pleasure. This chapter
describes these features. Please also read chapter 7.0 to get familiar with the menu of your new receiver.
6.1 Changing channels
Your new receiver is equipped with three ways to change channels.
1. Via direct access
2. Via the channel list and
3. Via the Ch+/Ch- or pq keys.
6.1.1 Direct access
To gain direct access to a certain channel, simply input its number with the 0~9 buttons on the remote
control. Channel numbers can be up to four digits long. Entering a number with less than four digits is
possible. After entering the channel number just wait a few seconds and your receiver will switch to the
selected channel.
12
The Fast Scan channel lists are maintained and updated automatically by
the service list provider and can't be edited. Editing of channels can only be
performed for channels which are saved above channel number 4000 or
additionally saved in favourite list(s). If you want to change to another list
you need to do a Factory Reset (see chapter 7.1.5 of the user manual on our
website: www.strong.tv/downloads/manuals/7504_UM_EN.pdf.)
5 min after switching the receiver to standby it will enter the deep sleep
mode. Within this time the receiver is able to start up quickly. Starting up
from deep sleep takes approx. 1 min.
Advertisement
Table of Contents
