Table of Contents
Advertisement
Satellite:
Position:
By pressing the pq buttons you can select OK to change or Cancel to discard.
7.1.1.5 new TP
This submenu allows adding one or more transponders to the database of the selected satellite. This
enables you to check the signal or adjust the antenna for this satellite. Further you can perform a
NIT Search on the new satellite when you have added the appropriate transponder. The full editing
functions are available in the Channel Search menu. Here use the pq buttons to navigate.
Frequency:
Symbol rate:
Polarization:
By pressing the pq buttons you can select OK to change or Cancel to discard. After all settings are
adjusted according to your system requirements, press
about the changes, use the pq buttons to select Yes to save or No to discard and confirm with ok. The
receiver will return to the selection screen and you can continue. If you want to delete a satellite press
the GREEn button. If you want to delete all satellites that have been setup press the YELLoW button to
do so. When all settings have been made, press
7.1.2 Channel search
Use this menu to perform an automatic, network or transponder channel search or to search on all
satellites that have been setup. Use pq to highlight an item and tu to change settings. Below the
settings you can find the search method selection.
Antenna
Satellite
Transponder list
For the further procedure in Edit TP and Add TP see chapter 7.1.1.2 Add TP. In Delete TP a message will be
displayed to apply your changes, use pq to select Yes to apply or No to cancel and confirm with ok.
Scan Mode
Channel Type TV & Radio will scan for TV and radio channels, TV for TV channels only and Radio for radio
channels only. After you have adjusted the settings for the preferred scan process, move to Scan selected
satellite with pq and then select the search method with tu. You can select between following
procedures: Scan selected satellite
Search All Sat
Search TP
Network Search
18
Press ok to open the keyboard and enter a new name with the 0 ~ 9 buttons
(max. 9 signs). When you have entered the preferred name, press pq to
choose OK in order to rename or choose Cancel to discard.
Use 0 ~ 9 to enter the orbital position. If necessary, you can use ok and pq
to change the hemisphere from E to W or vice versa.
Enter a frequency with the 0 ~ 9 buttons.
Enter the required symbol rate with the 0 ~ 9 buttons.
Here the polarization can be changed with tu.
Here you can change the antenna port with tu if you have configured more
than one satellite.
Here you will see the satellite that is assigned to the antenna in above, you
can only see the satellite(s) which has/have been setup in the Antenna Setup
menu before.
By pressing tu you can change between the transponders referring to the
selected satellite, you can also press ok to list up and select with pq or
P+/P-. Afterwards press ok to choose. Press RED to Edit TP, with GREEn you
can Delete TP and with bLUE you can enter data for a new transponder Add
TP.
Here you can decide which channels you want to scan for: Either scan all
channels FTA & $, for Free-To Air only FTA or use CA to scan for scrambled
channels only.
Scanning the selected satellite.
Scanning the selected satellites.*
Scanning the selected transponder.
NIT scanning the selected satellite.
to leave this menu. A message will inform
to leave this menu.
Advertisement
Table of Contents
