Table of Contents
Advertisement
Scan mode:
Select All to store scrambled and free to air channels or select Free to store only free to
air channels. Note: Scrambled channels cannot be viewed with this receiver.
Connection:
Use this option to adjust the established connection to your TV set. Select HDMI or TV
SCART.
*Availability of DVB/HoH subtitles depends on the broadcast. If such subtitles are not supported, then
most likely subtitles can be activated via Teletext if available.
When all settings have been made, move the highlight to OK and press Ok to continue.
NOTE:
Wrong region selection can lead to missing channels or channels being stored at
wrong positions in the channel list.
The receiver will now advance to the Aerial Adjustment screen.
This part of the wizard is of great help when setting up your antenna system.
Use
to move the highlight to the setting you wish to alter and use
pq
following settings are available:
Antenna Power: Set to On if you use an active antenna. When set to On, 5 V will be present at the ANT
IN connector of the receiver. Select Off for passive antennas.
Beeper:
Select On for an audible indication of signal reception. Off turns the beeper off.
Channel No.:
Select a channel that is known to carry a broadcast in your region. The Signal Strength
and Signal Quality bars give a visual indication of the reception. Adjust your antenna to
obtain maximum signal strength and quality.
When all settings have been made, press Ok to start scanning.
The receiver will search for all available channels now. Once scanning is finished, the receiver switches to
viewing mode.
TIP:
If the Welcome menu does not appear after switching on the receiver the first time,
reset the receiver to factory settings by pressing the MENU button and selecting
Load Factory Setting in the submenu Tools. (DEfaUlT PIN: 1234).
5.0 QUICk GUIDE TO USING YOUR RECEIvER
We at STRONG understand that you can't wait to enjoy your new high definition digital terrestrial
receiver. The following quick guide will make you familiar with the basic operation of this device. We do,
however, advice you to read the full manual to get the best performance from your receiver.
To turn your receiver ON or to Standby, use the q button on the remote control.
Choose the desired channel with the
the 0~9 buttons on the remote control or press Ok in viewing mode to display the channel list. The
volume can be adjusted with the
6.0 OPERaTION
Your new receiver is equipped with several features to make watching TV a true pleasure. This paragraph
describes these features. Please also read chapter 7.0 to get familiar with the menu of your receiver.
6.1 Changing channels
Following ways are possible for changing channels with your new receiver:
Via direct access using the 0~9 buttons.
Via the channel list through Ok and the PG+/PG- buttons.
Via the
buttons.
pq
6.1.1 Direct access via 0~9 buttons
To gain direct access to a certain channel, simply input its number with the 0~9 buttons on the remote
control. Channel numbers can be up to four digits long. Entering a number with less than four digits
6
buttons. Alternatively, you can digit the channel number with
pq
buttons.
tu
PaRT 1 • English
to change values. The
tu
Advertisement
Table of Contents
