Antenna Adjustment; Quick Guide To Using Your Receiver; Changing Channels - Strong SRT 8525 User Manual

PART 2 • English
Antenna Power:
When all settings have been made, move the highlight to Next and press ok to continue.
The receiver will now advance to the Antenna Adjustment screen.

4.1 Antenna Adjustment

In this menu you can adjust the antenna in order to ensure best signal quality.
Band:
Frequency channel:
Now you can adjust your aerial antenna to a proper position in order to get the best signal quality
and strength indication displayed.
Afterwards press q to move the highlight to Search and press ok to start the channel scan process.
The receiver will start searching for channels. Information about the scanned frequency, found TV
and radio channels and channel scan progress is displayed on screen. When the channel scan has
been completed, the receiver will tune on the first found TV channel.
noTE:

5.0 QUICk gUIDE To UsIng YoUR RECEIvER

We at STRONG understand that you can't wait to enjoy your new high definition digital terrestrial
receiver. The following quick guide will help you getting familiar with the basic operation of this
device. We do, however, advice you to read the full manual to get the best performance from your
receiver.
To switch your receiver ON or in standby, use the q button on the remote control or on the front
panel of your receiver.
If you will not use the receiver for a longer time, unplug it from the mains by unplugging the power
plug from the outlet.
noTE:

5.1 Changing channels

There are different ways to change channels:
Via direct access using the 0~9 buttons.
„ „
Via the channel list through the ok button.
„ „
Via the pq or P+ and P- buttons.
„ „
5.1.1 Direct access
To access to a channel directly, simply enter its number with the 0~9 buttons on the remote control.
Channel numbers can be up to four digits long. Entering a number with less than four digits is
possible. Just wait a few seconds and your receiver will switch to the channel number, or just press
ok after inserting.
Set to On if you use an active antenna. When set to On, 5 V will
be present on the ANT IN connector of the receiver. Select Off for
passive antennas or when connected to a house distribution system.
Allows you to select the frequency range according to your local
broadcast conditions. The default adjusted UHF range is the
mostly used one, so we recommend not to change this setting.
If you know that the VHF range is used in your country you can
select it with tu.
Select a channel/frequency that broadcasts digital TV channels in
the region where you live.
If the receiver hasn't found any channels by the end of the channel scan, it
is possible that your antenna is not installed/ aligned correctly. To ensure
good results and the proper antenna configuration, refer to qualified
professionals.
5 min after switching the receiver to standby it will enter the deep sleep
mode. Within this time the receiver is able to start up quickly. Starting up
from deep sleep takes approx. 40 sec.
7