Quick Guide For Using Your Receiver; Operation; Changing Channels - Strong SRT 8113 User Manual

PART 1 • English
Antenna Power:
noTE:
Once all settings are made, move the highlight to OK press ok to start scanning.
The receiver will now search for all available channels. Once scanning is finished, the receiver switches
to viewing mode.
TIP:

5.0 QuICk guIdE foR usIng YouR RECEIvER

We at STRONG understand that you can't wait to enjoy your new high definition digital terrestrial
receiver. The following quick guide will make you familiar with the basic operation of this device. We
do, however, advice you to read the full manual to get the best performance from your receiver.
To turn your receiver ON or to Standby, use the q button on the remote control.
Choose the desired channel with the p q buttons. Alternatively, you can digit the channel number
with the 0~9 buttons on the remote control. Or press ok in viewing mode to display the channel list.
The volume can be adjusted with the t u buttons.

6.0 oPERATIon

Your new receiver is equipped with several features to make watching TV a true pleasure. This
paragraph describes these features. Please also read chapter 7.0 to get familiar with the menu of your
receiver.

6.1 Changing channels

Your new receiver is equipped with four ways to change channels.
Via direct access using the 0~9 buttons.
„ „
Via the channel list trough ok button.
„ „
Via the Pg+ and Pg- keys.
„ „
Via the p q keys.
„ „
6.1.1 direct access via 0~9 buttons
To gain direct access to a certain channel, simply input its number with the 0~9 buttons on the
remote control. Channel numbers can be up to four digits long. Entering a number with less than
four digits is possible. Just wait a few seconds and your receiver will switch to the selected channel or
press ok immediately after selecting the channel number.
Set to On if you use an active antenna. When set to On, 5 V will be present
on the ANT IN connector of the receiver. Select Off for passive antennas. The
included antenna is a active type. If you using this antenna keep it selection
to On.
Wrong region selection can lead to missing channels or channels being
stored on wrong positions in the channel list. All default selections above are
most common to use.
If the Welcome "Easy install" menu does not appear after switching on the
receiver the first time, reset the receiver to factory settings by pressing the
mEnu button and selecting Factory Setting in the submenu Tools. (default
PIn: 1234)
7