Strong SRT 7504 User Manual page 17

Transponder
Press the RED button SAT Edit to rename the chosen satellite and press the GREEn button Add TP to add
a new transponder to this satellites database.
7.1.1.2 DisEqC 1.2 set-up
Use this menu to configure the motor position for each satellite which you want to receive. If you have
already configured satellites, use tu in the PAGE (1/8-8/8) selection which will help you navigating
easier through the 32 available positions. Select a position number and press ok to open its setup.
Satellite
Transponder
Movement Speed:
Move:
Centre Position:
Set Limit:
7.1.1.3 GoTo X set-up
Use this menu to configure the motor position through the GOTO-X function. If you have already
configured satellites, use tu in the PAGE (1/8-8/8) selection which will help you navigating easier
through the 32 available positions. Select a position number and press ok to open its setup.
Satellite
Transponder
Your longitude:
Your latitude:
GOTO:
Center Position:
noTE
7.1.1.4 sAT Edit
This submenu allows renaming of the chosen satellite or creating a new satellite position. Use pq to
choose Satellite or Position.
Press ok to open the list of available transponders for the chosen satellite, in
order to check your reception or align the antenna.
Press ok to open the list of available satellites and choose a satellite with pq
or P+/P- and confirm by pressing ok.
Press ok to open the list of available transponders if you need to adjust a
transponder for the above selected satellite.
Here you can change the motor speed Slow/Quick.
Press tu to move the dish to East or West. Carefully move it until you can
observe that both signal bars receive acceptable reception levels. When you
have found the selected satellite press
Press ok to move the motor to the centre position of 0 degrees. This is only
needed for the first time to adjust the dish correctly.
Press ok to open this submenu in order to adjust mechanical limits for your
dish. This is only necessary if your dish is damaged due to touching a wall or
similar mechanical margins.
Press ok to open the list of available satellites and choose a satellite with pq
or P+/P- and confirm by pressing ok.
Press ok to open the list of available transponders if you need to adjust a
transponder for the above selected satellite.
Use the 0 ~ 9 buttons to enter the value of your longitude. Press ok to
confirm the value.
Use the 0 ~ 9 buttons to enter the value of your latitude. Press ok to confirm
the value.
Press ok to move the motor to the wanted position according to your local
parameters. Press and select Yes to save this position.
Press ok to move the motor to the centre position of 0 degrees. This is only
needed for the first time to adjust the dish correctly.
Detailed information about correct values for your location can be found on
websites like dishpointer.com, itouchmap.com or other reliable sources.
and select Yes to save the position.
17