Quick Guide To Using Your Receiver; Operation; Changing Channels - Strong SRT 8202 User Manual

When all settings have been made, move the highlight to OK and press ok to continue.
The receiver will now advance to the Aerial Adjustment screen.
This part of the wizard is of great help when setting up your antenna system.
Use pq to move the highlight to the setting you wish to alter and use tu to change values. The
following settings are available:
Antenna Power:
Channel No.:
Beeper:
When all settings have been made, press ok to start scanning.
The receiver will search for all available channels now. Once scanning is finished, the receiver switches
to viewing mode.

5.0 QUICk GUIDE To USInG YoUR RECEIvER

We at STRONG understand that you can't wait to enjoy your new high definition digital terrestrial
receiver. The following quick guide will make you familiar with the basic operation of this device. We
do, however, advice you to read the full manual to get the best performance from your receiver.
To turn your receiver ON or to Standby, use the q button on the remote control.
Choose a channel with pq. Alternatively, you can digit the channel number with the 0~9 buttons
on the remote control or press ok in viewing mode to display the channel list. The volume can be
adjusted with tu.

6.0 oPERATIon

Your new receiver is equipped with several features to make watching TV a true pleasure. This
paragraph describes these features. Please also read chapter 7.0 to get familiar with the menu of your
receiver.

6.1 Changing channels

Following ways are possible for changing channels with your new receiver:
Via direct access using the 0~9 buttons.
„ „
Via the channel list using ok and the PG+/PG- buttons.
„ „
Via the pq buttons.
„ „
6.1.1 Direct access via 0~9 buttons
To gain direct access to a certain channel, simply input its number with the 0~9 buttons on the
remote control. Channel numbers can be up to four digits long. Entering a number with less than
four digits is possible. Just wait a few seconds and your receiver will switch to the selected channel or
press ok immediately after selecting the channel number.
Before connecting your antenna to the receiver, please read the user
manual of your antenna regarding antenna powering. This parameter is
recommended to set to On only for active internal or external antennas
which require power supply via an antenna cable with voltage of 5 V DC and
consume less than 50 mA. Otherwise, leave the setting Off (default).
Select a channel that is known to carry a broadcast in your region. The Signal
Strength and Signal Quality bars give a visual indication of the reception.
Adjust your antenna to obtain maximum signal strength and quality.
Select On for an audible indication of signal reception. Off (default) turns the
beeper off.
9