Quick Guide To Using Your Receiver; Changing Channels; Adjusting Volume And Audio; Info Banner - Strong SRT 8526 User Manual

5.0 QUICk gUIDE To UsIng YoUR RECEIvER

We at STRONG understand that you can't wait to enjoy your new high definition digital terrestrial
receiver. The following quick guide will help you getting familiar with the basic operation of this
device. We do, however, advice you to read the full manual to get the best performance from your
receiver.
To switch your receiver ON or in standby, use the q button on the remote control or on the front
panel of your receiver.
If you will not use the receiver for a longer time, unplug it from the mains by unplugging the power
plug from the outlet.
noTE:

5.1 Changing channels

There are different ways to change channels:
Via direct access using the 0~9 buttons.
„ „
Via the channel list through the ok button.
„ „
Via the pq or P+ and P- buttons.
„ „
5.1.1 Direct access
To access to a channel directly, simply enter its number with the 0~9 buttons on the remote control.
Channel numbers can be up to four digits long. Entering a number with less than four digits is
possible. Just wait a few seconds and your receiver will switch to the channel number, or just press
ok after inserting.
5.1.2 Channel list
Press ok in viewing mode to display the channel list. Use pq in the list to highlight your channel of
choice and press ok to switch to this channel. To scroll to the next or previous 9 channels you can also
use the P+/P- buttons. With the tu buttons you can toggle between the TV and radio channel list.
To change directly from TV to radio mode, press the Tv/R button.
By pressing the fAv button in viewing mode you can open the FAV group selection, if a favourite
list has been created. If more than one FAV list have been created then you can use the tu buttons
to toggle between the different FAV groups: Movies, News, Sports and Music.
5.1.3 Using pq or P+/P-
p switches to the next channel.
q switches to the previous channel.
P+ switches to the next channel.
P- switches to the previous channel.

5.2 Adjusting volume and audio

To adjust the volume you can use the v+/v- or tu buttons. To mute the audio output, press !, to
enable the audio output again, press ! again.
Some channels support a choice of different audio formats and/or languages. To select another
audio language, press AUDIo in viewing mode. A list with available audio languages will be
displayed. Use pq to select language and confirm with ok. The audio channel as stereo, mono left
and mono right can be selected with the tu buttons.

5.3 Info banner

Every time you switch to a channel, the info banner will be displayed. While watching TV you can
i
press the button to display it again to access information about the current channel and event.
i
Press twice for detailed programme and technical information.
8
5 min after switching the receiver to standby it will enter the deep sleep
mode. Within this time the receiver is able to start up quickly. Starting up
from deep sleep takes approx. 40 sec.
PART 2 • English