Troubleshooting - Strong SRT 7504 User Manual

noTE
7.5.2 set Timer
Timers can be used to schedule recordings or to switch to a certain channel at a specific time. It will
help you not to miss your favourite events. Above the settings you will see the current date and timer
displayed.
Timer Number
Channel
Timer Type:
Event Type:
Month:
Date:
Day:
Time:
Duration:
Enable:
By pressing the YELLoW Summary button you can check the set timers. Press the RED button to edit a
set timer. Then you can choose between Record and Turn ON by using the tu buttons. Enter the time
with the 0 ~ 9 buttons if you want to change it. Select OK to change the timer or Cancel to cancel it. The
bLUE button can be used to delete a timer and with the YELLoW button or
again. Timers set Enable to Yes are automatically available in the Summary. When all settings have been
made, press to leave the menu. When returning to viewing mode the receiver will inform with a
message that it saves your settings.
noTE

8.0 TRoUbLEshooTInG

There may be various reasons for abnormal operation of the receiver. Please check the receiver
according to the procedures shown below. If the receiver does not work properly after checking it,
please contact your local service line or STRONG dealer. Alternatively you can send a support mail via our
website: www.strong.tv. NEVER open or disassemble your receiver. This may cause a dangerous situation
and will void the warranty.
5 min after switching the receiver to standby it enters the deep sleep mode.
In this time the receiver is able to start up quickly. Starting up from deep
sleep takes approx. 1 min.
Use tu to select one of the ten available timers or press ok to list up.
With ok you can list the channel list in a new screen. Use pq or P+/P- to
select a channel and press ok again to apply this channel.
Choose between Once, Daily or Weekly.
Choose between Record or Turn ON.
Only available when Timer Type is Once. Use tu to select the month.
Only available when Timer Type is Once. Use tu to select the date.
Only available when Timer Type is Weekly. Use tu to select the day.
Use the 0~9 buttons to enter the time at which the timer should start.
Use the 0~9 buttons to digit the duration of the timer. For duration of 45 min,
just enter 45 and press ok or for 1h 30min, just enter 130 and press ok.
Choose between Yes or No. You have to choose Yes if you want the timer to
start at the set time.
If one timer is in conflict with another or if the set time already has passed,
the receiver will display a warning and ask how to solve the conflict.
you can close this menu
29