Rear Panel; Remote Control - Strong SRT 7504 User Manual

Digital high definition satellite receiver
Table of Contents

Advertisement

3. Indicator
4. smart card slot
5. Usb
noTE

2.3 Rear Panel

1. sAT In
2. sAT oUT
3. CoAXIAL s/PDIf
4. hDMI
5. Tv sCAR
6. Power switch
7. DC PoWER

2.4 Remote Control

1. q
2. !
3. 0~9
4. Tv/R
5.
6. fAv
7.
8. AUDIo
9. Info
10. EPG
11. pq
12. tu
13. ok
14. MEnU
15.
16. voL+/voL-
17. P+/P-
18. LIsT
19. Ch+/Ch-
20. oPT
8
LED GREEN indicates that the receiver is currently ON, GREEN and RED
alternating indicates that the receiver is preparing to enter deep sleep, RED
indicates that the receiver is currently in deep sleep mode.
To insert your valid and activated Irdeto smart card for proper reception of
your desired channel bouquet. For the correct insertion of smart card please
see the insertion drawing.
To connect your USB storage device
5 min after switching the receiver to standby it enters the deep sleep mode.
Within this time the receiver is able to start up quickly. Starting up from
deep sleep takes approx. 1 min.
To connect to the LNB of your satellite antenna for reception of satellite
broadcast signal
To loop through the satellite signal to a second receiver
To connect to a digital amplifier or home theatre
To connect to the HDMI input of your TV set using a good quality HDMI cable
To connect to your TV set using a SCART cable
To switch/power your receiver ON or OFF
To connect to the original included main power adapter (Input 110 ~240 V
50~60 Hz/ Output 12 V DC
Switches the receiver On/Standby
Mutes audio output of the receiver in every mode incl. videotext
Channel selection or value input
Toggles between TV and RADIO mode
No function
Opens the favourite list selection
Switches between the two last watched channels
Opens the list of audio languages
Shows the actual channel information (2x event info, 3x technical info)
Shows the EPG (Electronic Programme Guide) in TV mode
Menu Off: Change channel to next/previous. Menu On: Moves the cursor up/
down.
Menu Off: Decreases/increases the volume level. Menu On: Change settings
for specific Menus and for navigation
Menu Off: Displays the current channel list. Menu On: Opens the highlighted
setting or for confirmation
Opens the main menu and from main menu you will get one step back
Exits from the menu, sub-menu or cancels actions
Increases/decreases the volume in all modes incl. videotext
Scroll page wise in all lists
Shows the satellite selection in viewing mode, in EPG and Timer opens the
summary
Channel up/down
Opens the settings for TV format, aspect ratio and resolution
)
Fig. 2
Fig. 3

Advertisement

Table of Contents
loading

Table of Contents