Table of Contents
Advertisement
b: Connect one end of a good quality HDMI cable to the HDMI connector of your receiver and the other
end to the HDMI input of your TV set.
C: Plug the power adapter jack to the receiver and the other end to a suitable wall outlet.
Optional: If your TV set don't have an HDMI connector you can use the SCART connection instead. In
such case connect one end of a good quality SCART cable to the TV SCART of your receiver and the other
end to the SCART input of your TV set.
3.2 Extended connections for your home entertainment
A: Connect one end of a good quality coaxial audio cable to the S/PDIF output of your receiver and the
other end to the coaxial audio input of your home theatre, amplifier or any other device supporting
digital audio.
b: Connect your USB 2.0 storage device to this connector by using a good quality USB cable or insert the
device directly.
3.3 Connecting to multiple fixed antennas
A: Connect the LNBs of your fixed antenna to the desired inputs of a DiSEqC 1.0 switch using a good
quality coaxial cable and suitable 'F-connectors'.
b: Connect the output or "to receiver" of the DiSEqC 1.0 switch to the SAT IN connector on your receiver
using a good quality coaxial cable and suitable 'F-connectors'.
C: Plug the power adapter jack to the receiver and the other end to a suitable wall outlet.
3.4 Connecting to your motorised dish via DisEqC 1.2
Another possibility for watching programmes from multiple satellites is by mounting a dish to a
motorized DiSEqC 1.2 or GOTO-X positioner. For the correct setup and mounting of your motorised dish
we recommend referring to the advice of a professional satellite equipment installer to ensure correct
alignment and function. Please ensure that all connections are fitting well and are correctly assembled,
then you only need to connect the "OUT" connector of your positioner to the SAT IN connector on the
rear side of your receiver.
4.0 sTARTInG UP foR ThE fIRsT TIME
Ensure that your satellite signal is of good quality and that all connections are properly setup. In
case you encounter difficulties or you have questions, please ask your local dealer for assistance. It is
recommended to follow the First Time Installation step by step. It will guide you through the basic setup
and installation process. You will enjoy digital HD broadcasts within just a few minutes. If your receiver is
not already powered ON, against our expectation, please use the power switch on the rear side of your
receiver to switch it ON. In the unusual/uncommon case that the receiver should not start-up within
the First Time Installation, please reset the receiver with the factory reset. See chapter 7.1.5 of the user
manual on our website: www.strong.tv/downloads/manuals/7504_UM_EN.pdf. Please insert your valid
and activated Irdeto smart card for proper reception of the channel bouquet of your choice. For correct
insertion of the smart card please see the insertion drawing.
4.1 Language, Country and video settings
After connecting your receiver for the first time, the OSD language, Country and Video Setting menus will
be shown. First choose your language with tu then use pq to select your preferred country. For these
settings you can also use ok to show a list of available settings. Then use pq to select Video Setting.
In the Video Settings you can press tu to choose connection between HDMI and Scart. If necessary,
these settings can be opened by pressing ok. A detailed description of the settings can be found in the
10
Fig. 7.
Fig. 8.
Fig. 9
Advertisement
Table of Contents
