Quick Guide To Using Your Receiver - Strong SRT 8203 User Manual

English
«VIDEO», «INPUT», «Source» or with the symbol . If you have selected correct input, then
you will see on the on-screen of the receiver named «Init Install».
NOTE:
Select OSD Language. Press OK or u to start language selection.
Select Country and press OK or u to select the country of your residence.
Select LCN and press OK or u to select if the channel numbering should be according to LCN (as defined
by operator) or not.
Select Next and press OK or u to go to Antenna Setup menu.
This part of the wizard is of great help when setting up your antenna system.
Use pq to move the highlight to the setting you wish to alter and use OK or u to change values.
The following settings are available:
Active Antenna: Before connecting your antenna to the receiver, please read the user manual of your
antenna regarding antenna powering. This parameter is recommended to set to
On only for active internal or external antennas which require power supply via an
antenna cable with voltage of 5 V DC and consume less than 50 mA. In all other cases
please leave this parameter as Off.
Country Select the country of your residence.
Select On for an audible indication of signal reception. Off (default) turns the beeper
Beep:
off.
Channel No.: Select a channel that is known to carry a broadcast in your region. The Signal Strength
and Signal Quality bars give a visual indication of the reception. Adjust your antenna
to obtain maximum signal strength and quality.
Frequency: Reference information about frequency for the selected frequency channel. Parameter
could be defined manually if you prefer to adjust antenna by frequency.
Reference information about bandwidth for the selected frequency channel.
Bandwidth:
Parameter could be defined manually if you prefer to adjust antenna by frequency/
bandwidth parameters.
When all settings have been made, select Start Search and press OK or u to start scanning.
The receiver will search for all available channels now.
Once scanning is finished, the receiver switches to viewing mode.
You are now ready to watch TV.

5.0 QUICK GUIDE TO USING YOUR RECEIVER

We at STRONG understand that you can't wait to enjoy your new digital terrestrial receiver.
The following chapter will make you familiar with the basic operation of this device.
We do, however, advice you to read all chapters of this manual to get the best performance from your
receiver.
To turn your receiver ON or to Standby, use the q button on the remote control.
Choose a channel with pq (CH+/CH-) on the RCU. Alternatively, you can enter the channel number
with 0-9 buttons on the RCU or press OK in viewing mode to display the channel list.
The volume can be adjusted with t/u (VOL-/VOL+).
Depending from brand and model of your TV, the name of the HDMI input
can be different, for example: HDMI1, HDMI2.
9