Strong SRT 8105 ECO User Manual
  1. Manuals
  2. Brands
  3. Strong Manuals
  4. TV Receiver
  5. SRT 8105 ECO
  6. User manual

Strong SRT 8105 ECO User Manual

Digital high definition terrestrial receiver
Hide thumbs
Table of Contents

Advertisement

Quick Links

Digital High Definition Terrestrial Receiver
SRT 8105 ECO

User manual

Advertisement

Table of Contents
loading

Related Manuals for Strong SRT 8105 ECO

Summary of Contents for Strong SRT 8105 ECO

  • Page 1: User Manual

    Digital High Definition Terrestrial Receiver SRT 8105 ECO User manual...

  • Page 4: Table Of Contents

    7.5 Games 7.6 Media+ 8.0 TROUblESHOOTIng 9.0 TECHnICAl SPECIfICATIOnS STROng declares that this item complies with the basic requirements and other relevant regulations of directives 2004/108/EC and 73/23/EC, RoHS 2002/95/EC Subject to alterations. In consequence of continuous research and development technical specifications, design and appearance of products may change.

  • Page 5: Introduction

    PART 1 • English 1.0 InTRODUCTIOn 1.1 Safety Instructions DO nOT InSTAll YOUR RECEIvER: In a closed or poorly ventilated cabinet; directly on top of or under any other „ „ equipment; on a surface which might obstruct the ventilation slots. DO nOT EXPOSE THE RECEIvER OR ITS ACCESSORIES: To direct sunlight or any other equipment that generates heat;...

  • Page 6: Equipment Set-Up

    „ „ the receiver. Always make backups of data on your USB storage device before using it with this receiver. STRONG will not take responsibility for any loss of information or circumstances caused by loss of information. 2.0 YOUR RECEIvER 2.1 PIn-CODE DEfAUlT: 0000...

  • Page 7: Rear Panel

    PART 1 • English 2. USb: Connector for USB devices. 3. IR sensor: Point your remote control towards this sensor. 4. mode indicator: RED indicates that the receiver is in STAND-BY mode. GREEN indicates that the receiver is in OPERATING mode. 2.3 Rear Panel Fig.

  • Page 8: Connection

    3.3 Connecting to Tv with SCART cable Fig. 4 SRT 8105 ECO is also equipped with a SCART connector; alternatively, the TV set can be connected to the receiver using a good quality SCART cable. 3.4 Connecting to Tv with Cinch cable Fig.

  • Page 9: Connecting A Usb Storage Device

    For proper functioning of Time Shift and recording functions, a fast USB device (such as a hard disk drive) is needed. Interrupted playback or a distorted picture during playback or Time Shift are indications for a low device speed. STRONG cannot guarantee proper functioning of recoding and or Time Shift functions with all USB devices.

  • Page 10: Quick Guide To Using Your Receiver

    5.0 QUICk gUIDE TO USIng YOUR RECEIvER We at STRONG understand that you can’t wait to enjoy your new high definition digital terrestrial receiver. The following quick guide will make you familiar with the basic operation of this device. We do, however, advice you to read the full manual to get the best performance from your receiver.

  • Page 11: Info Banner

    PART 1 • English 6.2 Info banner While watching TV you can press the InfO button any time to get information about the current channel and event*. Press InfO twice for extended EPG details about the current channel. Press InfO three times for technical details about the current channel. *Event information is displayed when available.

  • Page 12: Instant Recording

    PART 1 • English 6.8 Instant Recording Your new receiver allows you to make an instant recording of the programme you are watching. Simply press 4 to start the recording. To enter the duration for the recording, press 4 again. Use the 0~9 keys to input the desired recording time.

  • Page 13: Moving Channels

    PART 1 • English 7.1.1.3 Skipping channels Channels marked with Skip will be skipped when zapping channels with the p/q buttons. Despite that, these channels are still available from the channel list. To mark channels for skipping, press gREEn while in TV Channel List. The Skip symbol on the top of the screen will move up to indicate that the Skip function is selected.

  • Page 14: Installation

    PART 1 • English 7.1.2 Radio Channel list Basically, the operation of the Radio Channel List is the same as in the TV Channel List. The only difference is that in Radio Channel List there is no video information, so it will always display the radio logo at the right preview screen.

  • Page 15: System Setup

    PART 1 • English 7.2.4 lCn (logical Channel numbering) If LCN (Logical Channel Numbering) is activated and an LCN signal is provided by the operator, channels will be stored in an operator defined order. Set LCN to On to activate operator defined channel numbering or Off to store channels in found order.

  • Page 16: Timer Setting

    PART 1 • English increasing by half hours progressively. The cities matching the set GMT Offset are displayed at the bottom of the screen. Summer Time: Select Off or On to add one hour extra for summer time during the summer. Date: Date and Time settings are available only when GMT Usage is set to Off.

  • Page 17: Tools

    This receiver is equipped with an Over The Air software upgrade option. An Over The Air update might not be available in your region. Please visit our website www.strong.tv or contact your local service hotline for more information about this option.

  • Page 18: Games

    This feature allows you to upgrade your receiver’s software via the USB port. If new software is available for your receiver, it can be downloaded from our website www.strong.tv.Place the software file (unzipped) in the root directory of your USB storage device (HDD, memory stick etc.) and insert this device into the USB port of the receiver.

  • Page 19: Hdd Format

    Formatting will permanently delete ALL data stored on the connected device. Please make a backup copy of all data you wish to keep before entering the HDD Format menu. STRONG cannot be held responsible for loss of data from USB devices used with this receiver.
  • Page 20 PART 1 • English 7.6.5 DvR Configuration This menu allows you to make settings for Time Shift, recording and playback. Select DVR Configuration from the Media+ menu and press Ok to enter. Use p/q to move the highlight and t/u to change settings. Press EXIT to quit.

  • Page 21: Troubleshooting

    Remote batteries exhausted Replace remote batteries Forgotten PIN code Contact local Service Hotline or send email to our Support via www.strong.tv After moving the receiver Antenna signals are too weak Press the InfO button on remote to another room/area 2x or 3x to call up signal bars and...

  • Page 22: Technical Specifications

    MP3 and FLAC formats* Picture view: JPEG format* *STRONG cannot guarantee the playback of video files although extensions are listed, as it depends on codec used, data bit rate and resolution (all MPEG codec formats are supported). Connectors ANT IN - IEC Female TO TV - IEC Male TV SCART (RGB, CVBS, Audio L&R)
  • Page 23 PART 1 • English general Data Supply Voltage: 220 - 240 V AC (SMPS), 50/60 Hz Power Consumption: 5.65 W (typ.), 12.00 W (max) Power consumption in Standby: 0.82 W Operating Temperature: 0 ~ 40 °C Storage Temperature: -30 ~ 80 °C Operating Humidity Range: 10~85%, RH, Non-condensing Size (WxDxH) in mm:...

Table of Contents