Audio And Subtitle Setup; Auto Diseqc Scan; Satellite Selection; Channel List Selection - Strong SRT 7504 User Manual

chapters 7.1.3.1 hDMI or 7.1.3.2 sCART of the user manual on our website: www.strong.tv/downloads/
manuals/7504_UM_EN.pdf.
noTE
Please read the displayed instructions for each screen carefully. They will help you adjusting the settings
fast and easy.During the First Time Installation, you can press bLUE Next to go to the next step or
YELLoW Previous to get back to the previous step.

4.2 Audio and subtitle setup

Here you can set the Audio Language, Audio output, Subtitle Display and Subtitle Language. Use pq for
selection and tu to change settings. To see a list of all possible settings for the highlighted option,
press ok. Once all settings have been made, press bLUE Next to continue or YELLoW Previous to get
back to the previous setup screen.
Please read the displayed instructions for each screen carefully. They will help you adjusting the settings
fast and easy.

4.3 Auto DisEqC scan

In this menu the receiver will do an automatic scan for connected LNBs and suitable satellites. The most
common satellites as Astra 23.5E, Astra 19.2E, Astra 28.2E, HotBird 13.0E and Eutelsat 9.0E will be scanned
for availability. Please wait for a short time to let the receiver complete the scan and then apply the
settings to the next step by pressing ok at Next. Press ok at Previous if you have forgotten to connect
a satellite cable or need to correct anything else that was adjusted before. Once the Auto DiSEqC scan is
finished and you have confirmed with ok you will automatically receive at the next step of FTI. To ensure
reception and to scan the channels from your operator follow the Fast Scan method in the next steps.
For this the reception of Astra 23.5E is essential.

4.4 satellite selection

Depending on the results of the found satellites in the previous installation step it is possible to setup
other or additional satellites connected to your installation system. This might be useful if you have other
satellites installed on the LNB which are not commonly used ones or if the found satellites need rework.
To check or change your settings for the satellite(s) connected to the ports, use pq and press ok to
enter the submenu of your choice (LNB and the configured satellite will be according to Auto DiSEqC
Scan result). This you can do for up to 4 satellite positions. For a detailed description of this setup, please
see chapter below. Once all settings have been made, press bLUE Next to continue.

4.5 Channel List selection

Here you can decide which of the Fast Scan channel lists you want to install. Use pq to highlight your
selection in orange coloured letters. Press ok to choose a list and the receiver will start the scan for the
list directly. Please, have patience as this takes some time. When the list has successfully been loaded, the
First Time Installation will be finished.
If you select an HDMI resolution which your TV does not support, the
receiver will switch to the previous setting automatically after ~10 sec.
When you see the displayed message, please confirm the selected
resolution by pressing ok.
11