Accessories; Usage Of External Usb Devices; Your Receiver 2.1 Default Pin-Code: 0000; Front Panel - Strong SRT 7504 User Manual

The user manual available on our website www.strong.tv/downloads/manuals/7504_UM_EN.pdf
provides complete instructions for installing and using this receiver. The following symbols will serve as
follows.
WARnInG
noTE
MEnU
(bold characters)
Move to
(Italic characters)

1.4 Accessories

1x Quick Installation Guide
„ „
1x remote control unit
„ „
2x batteries (AAA type)
„ „
1x adapter 12 Volt DC, 2 Ampere
„ „
WARnInG

1.5 Usage of external Usb devices

It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0
„ „
specifications, recording, Timeshift and playback with your receiver might not work properly.
If you are going to use external USB HDD (Hard Disk Drive) please consider that it might be the case
„ „
that the power specifications exceed the supported output of your receiver (5V/1A). If so, please
connect your USB HDD to an according external power adapter.
STRONG cannot guarantee compatibility with all types of USB storage devices.
„ „
It is advised not to store important information on USB storage devices used with the receiver.
„ „
Always make backups of data on your USB storage device before using it with this receiver.
STRONG will not take responsibility for any loss of information or circumstances caused by loss of
information.
Please ensure that either the USB device is already formatted to FAT32, or format the USB device via
„ „
your receiver, refer to chapter 7.4.4 HDD Manager in the user manual available on our website www.
strong.tv/downloads/manuals/7504_UM_EN.pdf for details.
STRONG cannot guarantee the playback of all files although extensions are listed, as it depends on
„ „
file size, codec, bit rate and resolution.
2.0 YoUR RECEIvER
2.1 DEfAULT PIn-CoDE: 0000

2.2 front Panel

1. standby/on button Switches the receiver ON or into Standby
2. IR sensor
ndicates warning information.
Indicates any other additional important or helpful information.
Represents a button on the remote control or the receiver.
Represents a menu item within a screen.
The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries. If rechargeable
accumulators instead of batteries are going to be used, we recommend
using (e.g. NiMH) types with low self-discharge to ensure long time
operation of remote control.
Receives the RCU commands
Fig.1
7