System Settings - Strong SRT 7504 User Manual

Fast scan:
When all settings have been made, press ok at the preferred scan method to start this scan process or
to quit without scanning. All newly found channels will be stored at the end of the channel list.
*Only available if more than one satellite has been setup.
noTE
noTE

7.1.3 system settings

Use the System Settings menu to configure settings for language, audio, video, look and feel of your
receiver. Choose a setting with pq and press ok to list the possibilities or use tu to change the value
of the highlighted setting. Please also read the displayed instructions for each screen carefully. They will
help you to adjust the settings correctly and easily.
Language:
Video Setting:
Audio Output:
Audio language:
Subtitle Setting
Start up channel
Banner display time:
OSD transparency:
When all settings have been made, press
viewing mode the receiver informs with a message that it saves your settings.
7.1.3.1 hDMI
In this submenu you can set following parameters:
Will rescan the channel list supplied by the operator that you have chosen.
Fast Scan is only available on Astra 23.5E.
NIT (Network Identification Table): This option will scan on the NIT table of
the satellite and allows you to receive new appeared channels.
When you want to add technical data for a new transponder we
recommend verifying it by consulting websites like: www.lyngsat.com or
www.kingofsat.net or you can refer to professional journals.
Here you can change the language for the On-Screen-Display, use tu to
select your preferred language. It affects the menu language of your receiver
so all menus and messages will be displayed in the chosen language.
Select the connection to your TV set. Either Scart or HDMI can be selected via
tu. Press ok at the used connection to open the settings for it. For details,
see chapter 7.1.3.1 hDMI or 7.1.3.2 sCART.
Here you can adjust the settings for your digital audio output. Press tu
to choose between BitStream and PCM. If a device that can decode Dolby®
Digital is connected, use the setting BitStream. If this is not possible, use PCM.
Press ok to open the setting. The most important audio languages are
displayed. For details, see chapter 7.1.3.3 select Audio Language.
Press ok to open this setting. For details, see chapter 7.1.3.4 select subtitle
Language
In this menu you can select your start up channel. Select Last watched if you
want to start with the last viewed channel when the receiver was switched
off. To switch on with a specific channel, select Fixed Channel by pressing tu.
Press ok and ok again to continue. Press pq or P+/P- to scroll in the list and
confirm your selection with ok.
Defines the time for displaying the information banner. Press tu to choose
between 1 sec ~ 20 sec.
Defines the transparency of menus and banner. Press tu to choose between
25%, 50%, 75% and fifty-fifty.
to leave the System Settings menu. When returning to
19