Power Trim; Steering Wheel; Trim Tabs - Pro-Line Boats 2010 29 Express Owner's Manual

Power Trim

The power trim unit is located on the engine and can be operated by using the trim button on the engine or by
using the trim toggle switch on the binnacle. To ensure the power trim is working, start by pressing the toggle trim
switch in the up position and trim the engine to the full up position. Repeat the same process by pressing the trim
toggle switch down and the engine will go into the full down position. See the Trim and Tilt information in the
Operations section of this manual.

Steering Wheel

The stainless steel steering wheel is mounted at the helm along with the
binnacle, switch panel and other controls. Please refer to the Care and
Maintenance section of this manual for cleaning recommendations.

Trim Tabs

The trim tabs come equipped with auto retract. The planing tabs are located on each side of the transom on the
bottom of the hull. The trim tabs operate independently, up or down, to correct for differing conditions of wind or
load. Refer to the owner's packet for specific information.
Check the operations of your trim tabs before getting underway. To operate the trim tabs locate the trim tab
rocker switches on the console. Press both switches forward and hold them down. This will engage both trim
tabs and will ensure they are working properly while in the full down position.
The switch on the port side operates the starboard trim tab. The switch on the starboard side operates the port
trim tab. To check each trim tab individually, press one of the trim tab rocker switches forward and check to see if
the opposite trim tab goes down. For example if the starboard trim tab switch is being pressed down, the port trim
tab should be going down. Repeat the same process for the opposite side.
12