Charging The Redmike - Lightspeed Redcat User Manual

4. CHARGING THE REDMIKE

Before use, the Redmike should be charged. It will take 8-9 hours for the
Redmike to obtain a full charge. A fully charged Redmike will last for over 7
hours of use. If microphones are used daily, they should be kept in the cradle –
microphones can be left in a charging cradle constantly for up to 2 weeks without
causing degradation to battery life.
A red light on the charging cradle indicates the Redmike is charging. A green
light indicates that charging is complete and a full charge has been reached. A
blinking light indicates a charging or sensing error. See Troubleshooting section
for more information.
Redmike incorporates alkaline protection into the microphone design. Always
use a Lightspeed rechargeable sensing battery. Replacement AA NiMH batteries
may only be purchased through Lightspeed Technologies (part # NH2A27). Do
not attempt to charge alkaline batteries. They can overheat and expand creating
a significant hazard and damaging the microphone (this is not covered by
warranty).
1. Plug power cord into the cradle
charger and then plug the AC end
into an electrical outlet.
2. Place the Redmike into the cradle.
The LED on the cradle will glow
red indicating charging has
started. When the Redmike is fully
charged the LED on the cradle
charger will change to green.
16