Connecting The Main Unit And Ai Pulse Wave Measurement Unit Inserting The Memory Card - Omron HEM-9000AI Instruction Manual

8.2. Connecting the Main Unit and AI Pulse Wave Measurement Unit
Inserting the Memory Card
1.
Make sure that the power switch is in the OFF
position. [Fig. 1]
2.
Insert the air plug of the blood pressure cuff in the air
connector on the left side of the main unit. (Refer to
9.1.) [Fig. 2]
3.
Attach the rubber wrist rest to the pulse wave
measurement unit
Attach the wrist rest so that the side marked "thumb
side" is on the thumb side of the arm (i.e., the thumb
side is on the left side of the patient when using the
patient's left hand for measurement and on the
patient's right side for right-hand measurement).
4.
Plug one end of the connection cable (see Section 5.
for illustration) into the main unit connector on the
back of the AI pulse wave measurement unit. The
plug will click and lock into place. [Fig. 3]
5.
Plug the other end of the connection cable into the
AI measurement unit connector on the back of the
main unit. [Fig. 4]
6.
Plug the connection cable of the AI Pulse Wave
sensor unit into the AI Pulse Wave sensor unit
connector.
Attach the air plug of the AI Pulse Ware Sensor unit
on the Air connector. [Fig. 5]
A cap is attached on the sensor when the unit is
shipped. Remove it before you use it for the first
time.
8.General Preparation
[Fig. 1]
[Fig. 2]
[Fig. 3]
EN
[Fig. 4]
[Fig. 5]
17