Reverting To Factory Default Settings; Updating The Software - NETGEAR STM150 Appliance Reference Manual

ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual
The STM restarts. During the reboot process, the Backup and Restore Settings screen remains
visible. The reboot process is complete after several minutes when the Test LED on the front panel
goes off.
Warning: Once you start restoring settings, do not interrupt the process. Do not try
to go online, turn off the STM, shut down the computer, or do anything
else to the STM until the settings have been fully restored.

Reverting to Factory Default Settings

To reset the STM to the original factory default settings, click the default button next to Revert to
factory default settings on the Backup and Restore Settings screen (see
The STM restarts. The Backup and Restore Settings screen remains visible during the reboot
process. The reboot process is complete after several minutes when the Test LED (STM150) or
Status LED (STM300 and STM600) on the front panel goes off.
Warning: When you restore the factory default settings, the STM settings will be
erased. All content settings and scan settings will be lost. Backup your
settings if you intend on using them.
Note: After rebooting with factory default settings, the STM administrator account
password will be password, the guest account password will be guest, and the
LAN IP address will be 192.168.1.201.
Note: For the STM150 only, there is an alternate way to return the settings to factory
default: using a sharp object, press and hold the Reset button on the rear panel of
the STM150 (see
the front panel Test LED flashes and the STM150 returns to factory default
settings.

Updating the Software

If you have used the Setup Wizard, you might have already configured the software update
settings; the Software Update screen allows you to modify these settings.
3-18
"Rear Panel STM150" on page
Performing Network and System Management
v1.0, September 2009
Figure 3-9 on page
1-14) for about 10 seconds until
3-16).