Restoring The Default Configuration And Password - NETGEAR STM150 Appliance Reference Manual

ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual
• Check to see that the network address of your PC (the portion of the IP address that is
specified by the netmask) is different from the network address of the remote device.
• Check that the modem or router is connected and functioning.

Restoring the Default Configuration and Password

To reset the STM to its original factory default settings:
1. Select Administration > Backup and Restore Settings from the menu (see
Figure 7-1
2. Next to Revert to factory default settings, click the default button.
The STM restarts. During the reboot process, the Backup & Restore Settings screen remains
visible. The reboot process is complete after several minutes when the Test LED (STM150) or
Status LED (STM300 and STM600) on the front panel goes off.
Warning: When you restore the factory default settings, the STM settings will be
erased. All content settings and scan settings will be lost. Backup your
settings if you intend on using them.
Note: After rebooting with factory default settings, the STM administrator account
password will be password, the guest account password will be guest, and the
LAN IP address will be 192.168.1.201.
7-6 Troubleshooting and Using Online Support
v1.0, September 2009
Figure 7-1).