NETGEAR STM150 Appliance Reference Manual page 122

ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual
Figure 4-9
2. Complete the fields and select the checkboxes as explained in
Table 4-9. Web Policy Settings
Setting Description
Services to Scan
HTTP Select the HTTP checkbox to enable Hypertext Transfer Protocol (HTTP) scanning.
This service is enabled by default and uses default port 80.
HTTPS Select the HTTPS checkbox to enable Hypertext Transfer Protocol over Secure Socket
Layer (HTTPS). This service is disabled by default and uses default port 443.
Note: Skype cannot log in through port 443 when you enable HTTPS scanning.
FTP Select the FTP checkbox to enable File Transfer Protocol (FTP). This service is enabled
by default and uses default port 21.
Note: If a protocol uses a port other than the standard service port (for example,
port 80 for HTTP), enter this non-standard port in the Ports to Scan field. For
example, if the HTTP service on your network uses both port 80 and
port 8080, enter both port numbers in the Ports to Scan field and separate them
by a comma.
3. Click Apply to save your settings
4-24 Content Filtering and Optimizing Scans
v1.0, September 2009
Table 4-8.