What To Do Next - NETGEAR STM150 Appliance Reference Manual

ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual
The STM will activate the licenses and register the unit with the NETGEAR registration server.
Note: When you reset the STM to the original factory default settings after you have
entered the license keys to activate the STM (see
NETGEAR" on page
different types of licenses that are available for the STM are no longer displayed
on the Registration screen. However, after you have reconfigured the STM to
connect to the Internet and to the NETGEAR registration server, the STM
retrieves and restores all registration information based on its MAC address and
hardware serial number. You do not need to re-enter the license keys and re-
activate the STM.

What to Do Next

You have completed setting up and deploying the STM to the network. The STM is now set up to
scan the protocols and services that you specified for malware and to perform updates based on the
configured update source and frequency.
If you need to change the settings, or to view reports or logs, log in to the STM Web Management
Interface, using the default IP address or the IP address that you assigned to the STM in
Wizard Step 1 of 10: Introduction" on page
The STM is ready for use. However, some important tasks that you might want to address before
you deploy the STM in your network are listed below:
• "Changing Administrative Passwords and Timeouts" on page
• "Managing Digital Certificates" on page
• "Configuring Groups" on page
• "Configuring User Accounts" on page
• "Configuring Authentication" on page
• "Setting Scanning Exclusions and Web Access Exceptions" on page
2-30
2-28), the license keys are erased. The license keys and the
2-10.
3-25.
5-2.
5-7.
5-9.
Using the Setup Wizard to Provision the STM in Your Network
v1.0, September 2009
"Registering the STM with
3-9.
4-49.
"Setup