Table of Contents
Advertisement
Chapter 16 Parameters and Defaults
The tables below list the parameters and their defaults. Those parameters can be changed with the QR-coded parameter menu
or configuration software (QB Setting), except shadowed ones only with the configuration software.
When the scanner leaves the factory, all of these parameters are set to defaults.
(1) Reading mode related parameters
Items
Data verification mode
Data edit mode
Bar code reader mode
Double scan prevention time
Decode limitation time
Luminosity setting
Shutter time
Gain level
External illumination
synchronized signal
Data Output Timing
Unread cord transmission
Unread cord
Scanning start command
Scanning end command
(Note 1) 0x20～0x7E can be registered excluding the control characters of ASCII character codes.
Parameters
Regular read mode
Scan entry mode
File entry mode
Non-edit mode
Data extraction mode
Data conversion mode
Blocksorting mode
ADF script mode
Enabled
Disabled
Double scan enabled
Double scan prevention time
Setting range 0.1- 9.9 seconds
Disabled
0.05s – 9.99 s
Automatic
Fixed shutter, Variable gain
Fixed shutter, Fixed gain
0.1-9.9ms
0-15
TrOn
TrOff
Synchronous
Asynchronous
Disabled
Enabled
Designate up to 7 characters with
ASCII characters
Designate up to 7 characters with
ASCII characters
Designate up to 7 characters with
ASCII characters
: Can be changed only with the configuration software.
74
Defaults
Chapter 8
Section 8.1
Chapter 8
Section 8.2
Chapter 8
Section 8.6
Chapter 5
0.5 seconds
Chapter 8
Section 8.5
Chapter 10
0.5ms
8
Chapter 11
Section 11.6
Chapter 11
Section 11.4
Chapter 7
(Note 1)
"ERROR"
Chapter 7
(Note1)
"READON"
Chapter 7
"READOFF"
Chapter 7
(Note1)
Refer to:
Advertisement
Table of Contents
