Table of Contents
Advertisement
Setting command
Software version check
Beeper beeping
Beeper beeping when scanning
is unsuccessful
Magic key functions setting
Beeper beeping when power is
on
Conditions
Received an undefined command
(Header and terminator are matched.)
Received a control command after entering
setting mode.
(Header and terminator are matched.)
Received only a setting command/menu
(Header and terminator are matched.)
The value of setting command is invalid
Receiving error occurred.
(Parity error, framing error)
Non-scan code
Optional Setting Commands
Transmitted command
(Confirmation) RD31
(Change) WR33#n
(Change) RD33
(Change) WR35#n
(Confirmation) RD35
(Change) WR37#n
(Confirmation) RD37
(Change) WR38#n
(Change) RD36
Error Processing
Response
NG transmitted
(can be set by a command)
123
Response
VER.n.nn
OK
n=0: Enabled
n
n=1: Disabled
OK
n=0: Enabled
n
n=1: Disabled
OK
n=0: Enabled
n
n=1: Disabled
OK
n=0: Enabled
n
n=1: Disabled
No response
ERROR
Advertisement
Table of Contents
