Table of Contents
Advertisement
Windows Vista
(1) Switch the computer on to run Windows Vista. Log on as an Administrator.
(2) Connect the scanner's USB interface cable to the computer or USB hub.
(3) Wait for the Installing device driver software hint to pop up on the Windows
task tray.
Windows will automatically configure the scanner. Upon completion of the
configuration, the screen shown at left automatically disappears.
(4) Wait for the USB Human Interface Device hint to pop up on the task tray.
(5) To check whether the USB device is working normally, open the Windows
Device Manager.
If USB Human Interface Device is added to the sub-tree of Human Interface
Devices as shown at left, the scanner is connected normally.
If the device is not added or it is marked with
the uninstaller, reboot your computer, and perform the above connection process
again.
14
or
, remove this driver with
Advertisement
Table of Contents
