Setting Up The Usb Keyboard Interface - Denso QB30-SR User Manual

4.2.2

Setting up the USB keyboard interface

The USB keyboard interface requires the USB device class driver for HID (Human Interface Device) which is included in
Windows 98 or later Operating Systems and whose setup wizard will automatically run. You do not need to install the device
driver.
Note: If the USB-COM interface is set up, switch it to the USB keyboard interface by scanning the "USB keyboard interface"
QR Code symbol given in Section 17.3 with the parameter setting procedure in Section 17.1. (Plugging the USB interface
cable in the scanner automatically switches to the USB-COM interface by default.)
Connecting the USB interface cable to the host's USB port or USB hub automatically runs the system-supplied driver setup
wizard. Follow the wizard and set up the driver. The setup procedure on each of Windows XP and Windows Vista is described
below. Follow the wizard for Windows 7 as well.
Windows XP
(1) Switch the computer on to run Windows XP. Log on as an Administrator.
(2) Connect the scanner's USB interface cable to the computer or USB hub.
(3) Wait for the Found New Hardware hint to pop up on the Windows task tray.
Windows will automatically configure the scanner. Upon completion of the
configuration, the screen shown at left automatically disappears.
(4) To check whether the USB device is working normally, open Windows Device
Manager.
If USB Human Interface Device is added to the sub-tree of Human Interface
Devices as shown at left, the scanner is connected normally.
If the device is not added or it is marked with
the uninstaller, reboot your computer, and perform the above connection process
again.
13
or , remove this driver with