Chapter 3. Parameters And Defaults - Denso QS20H User Manual

Chapter 3. Parameters and Defaults

The table below lists the parameters and their default values. Note that the
defaults given below are values preset when the QS20H leaves the factory.
Some of the communications parameters and readable bar code settings may
have been modified by dealers according to your needs.
You may change parameters given in the table below by using the QR-coded
parameter menu given in Chapter 4. Settings made from the QR-coded param-
eter menu will be stored in the memory of the QS20H.
Parameter group
Communications
mode
Communications
conditions
Transmission
format
Parameters
Procedure
Transmission rate
Character length
Parity check
Stop bit length
Header
Terminator
Transmission of code
ID mark (see p. 21)
Transmission of no.
of digits
BCC
Function
Non-acknowledge mode
ACK/NAK mode
4800 bps
9600 bps
19200 bps
38400 bps
57600 bps
115200 bps
8 bits
7 bits
No
Even parity
Odd parity
1 bit
2 bits
None
STX
ETX
CR
LF
CR LF
Disabled
Enabled
Disabled
Enabled
Disabled
Enabled
7
Factory defaults
√
√
√
√
√
√
√
√
√
√