Illumination Leds - Denso QB30-SR User Manual

I, when the scanner is broken.
Even if indicator LED illumination has been disabled at the QR Code menu or with the configuration software(QB Setting),
this setting does not apply in the following cases.
 When set at the QR Code menu.
 An indicator LED illumination command is received from the host.
 Settings are reflected when the configuration settings are started up.
 Setting with a batch settting QR code.
 While in master code registration mode when performing data verification.
 If no master code has been registered when performing data verification.
 If master code registration is completed when performing data verification.
 If an error occurs during master code registration when performing data verification.
 When unable to save settings.
 When an execution error occurs with ADF script.
 When the trigger switch is pressed when trigger switch control is disabled.
 Power on indication
 Malfanction indication
 When in the setting mode
 When magic key is in the scanning ON/OFF mode and the continuous reading mode B.
 When magic key is in the illumination change mode.
9.3

Illumination LEDs

When the scanner is ready to scan, the illumination LEDs flash.
The illumination LEDs provide the three choices--Always ON, Automatic, Always OFF by using the command and
configuration software (QB Setting).
For QB30-SU, illumination light (LED) turns off when beeper is beeping even if Always-Turn ON is set.
44