Chapter 8 Scanning Functions; Data Verification Mode; Scan Entry Mode; Master Data Registration With Magic Key - Denso QB30-SR User Manual

Chapter 8 Scanning Functions
8.1

Data Verification Mode

The data verification mode verifies the code data read against the master data stored in the scanner and reports the match status
with data output.
8.1.1

Scan entry mode

Scan a code and set the content as the verification master. The scanner enters master data registration mode after the magic key
is pressed for two seconds or the master registration command is sent with the permission of scan entry verification by
configuration software (QB Setting) or commands, and the first scanned code is used as master data. Only one master data can
be registered, the position of the verification digit can be specified. The output format for the verification result can be
selected , with the position of the verification digit and verification result output format being set using the commands or
configuration software(QB Setting). Verification are made on 1:n basis , with the maximum number of comparable data digits
being 255.
8.1.1.1

Master data registration with magic key

The following chart is the procedure of master data registration with a magic key.
Note1: The scanner enters master data registration mode while the magic key is pressed. The scanner enters the normal
scanning mode if the magic key is released.
Note2: The registered master(s) is deleted when the power is turned OFF.
START
Keep pressing magic key 2s
Master code scanning
No
Decode successful?
Master registration
END
19
Note 1
Note 2