Switch Driver Commands; Figure 28-19 Display Switch Driver Counters; Table 28-9 Switch Driver Commands; Table 28-10 Display Switch Driver Counters - ZyXEL Communications IES-2000 User Manual

FIELD
ConfigPending
ForwardTransition
STP Counter
SendConfCount:
SendTCNCount
RecConfigBPDU
RecTCNBPDU

28.8 Switch Driver Commands

The following table shows the switch driver commands supported by the VLC1012.
switch driver count disp
switch driver count clear
28.8.1 Display Switch Driver Counter Command
Syntax:
sw driver count disp
Use this command to show NDIS-level (Network Driver Interface Specification, a network interface card
specification) counters.
FIELD
TxPktCnt This is the number of transmitted packets.
RxPktCnt This is the number of received packets.
TxBufFullCnt This is the number of buffer allocation failures while transmitting packets.
Switch-Related Commands
Table 28-8 Menu 24.1.2 - Spanning Tree Protocol Status
This shows whether (1) or not (0) a configuration BPDU should be sent upon
expiration of the hold time period.
This is the number of times that this port has changed from learning stat to forwarding
state.
This is the total number of configuration BPDUs that this device has sent out.
This is the total number of topology change notification messages that this device has
sent out.
This is the total number of configuration BPDUs that this device has received.
This is the total number of topology change notification messages that this device has
received.

Table 28-9 Switch Driver Commands

COMMAND
vlc1012> sw driver count disp
TxPktCnt = 79287
TxBufFullCnt = 0
TxFreeCnt = 79287

Figure 28-19 Display Switch Driver Counters

Table 28-10 Display Switch Driver Counters

DESCRIPTION
DESCRIPTION
This command shows the switch counter.
This command clears the switch counters.
RxPktCnt = 281259
RxNoBufCnt = 0
DESCRIPTION
IES-2000/3000 User's Guide
28-19