Vdsl Commands; Figure 27-2 Ci Commands; Table 27-2 Vdsl-Related Commands - ZyXEL Communications IES-2000 User Manual

IES-2000/3000 User's Guide

27.2 VDSL Commands

The following table is a summary of VDSL-related commands.
COMMAND
vdsl uprate chan-id (x)
vdsl downrate chan-id (y)
vdsl patch chan-id [lt|nt]
vdsl reset chan-id [lt|nt]
vdsl reconnect chan-id
vdsl clear chan-id
vdsl debug chan-id [on|off]
vdsl monitor chan-id [on|off]
vdsl status chan-id
vdsl show chan-id
vdsl mode chan-id (mode)
vdsl active chan-id [on|off]
vdsl autoupg chan-id [on|off]
vdsl ver
vdsl quality chan-id
vdsl enet status chan-id
vdsl enet clear chan-id
vdsl enet monitor chan-id [on|off] This command sets the VDSL chip Ethernet monitor flag
vdsl enet phy chan-id
( ,
chan-id vdsl01 vdsl02
channel name that indicates all channels.
All VDSL parameters and flags set using VDSL commands are effective at run-time only. If you
restart the VLC1012, you will lose the configuration changes you made with commands. To save
changes permanently, please use the appropriate SMT menu.
27-2
vlc1012> ?
Valid commands are:
sys exit
vdsl bridge
vlc1012>

Figure 27-2 CI Commands

Table 27-2 VDSL-related Commands

This command sets the VDSL upstream rate (0 to 4)
This command sets the VDSL downstream rate (0 to 4)
This command loads new VDSL modem code into the VLC1012 (nt)
or VDSL subscriber modem (lt).
This command resets the VDSL chip.
Make VDSL reconnect
Clear VDSL related counters
This command sets the VDSL debug flag.
This command sets the VDSL monitor flag.
This command shows the VDSL status counters.
This command shows VDSL settings.
This command changes the VDSL mode (0 = 10BaseS, 1 = ANSI, 2
= ETSI).
This command actives/deactivates the VDSL driver.
This command enables/disables NT modem F/W auto upgrade.
This command shows the VDSL driver version.
This command shows VDSL quality.
This command shows Ethernet status counters.
This command clears Ethernet status counters.
This command shows the NT Ethernet PHY registers.
,... ) refers to the channel name for each VDSL channel.
vdsl12
device ether
sw monitor
DESCRIPTION
VDSL-Related Commands
is also a valid
all