Vdsl-Related Commands; Introduction; Figure 27-1 Ci Command Mode; Table 27-1 Vdsl Default Values - ZyXEL Communications IES-2000 User Manual

27.1 Introduction

CI commands contain advanced configuration features that may be used for debugging and troubleshooting.
Exercise caution when using CI commands as incorrect usage may damage your VLC1012.
27.1.1 VDSL Default Values
The default values for the following VDSL parameters are shown in the next table.
VDSL PARAMETER
VDSL Mode
VDSL Active
VDSL Upstream Rate
VDSL Downstream Rate
Enter 8 from menu 24 to go to CI command mode.
Type "?" to see the first level of commands.

VDSL-Related Commands

VDSL-Related Commands
This chapter shows you how to configure VDSL using line interface commands.

Table 27-1 VDSL Default Values

Menu 24 — System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Upload Firmware
8. Command Interpreter Mode
11. Remote Management Control
12. Hardware Monitor
Enter Menu Selection Number:

Figure 27-1 CI Command Mode

Chapter 27
DEFAULT VALUE
0 = 10BaseS mode
On
12.5 Mbps
12.5 Mbps
IES-2000/3000 User's Guide
27-1