Figure 25-2 Ftp Session Example; Table 25-2 General Commands For Gui-Based Ftp Clients; Example Of Ftp Commands From The Command Line - ZyXEL Communications IES-2000 User Manual

earlier in this chapter for more information on filename conventions.
Enter "quit" to exit the ftp prompt.
Step 7.
25.2.3

Example of FTP Commands from the Command Line

25.2.4 GUI-based FTP Clients
The following table describes some of the commands that you may see in GUI-based FTP clients.
COMMAND
Host Address
Login Type
Transfer Type
Initial Remote Directory
Initial Local Directory
25.2.5 TFTP and FTP over WAN Restrictions
TFTP and FTP over WAN will not work when:
•
FTP service is disabled in menu 24.11.
•
The IP address(es) in the Secured Client Sets menu (menu 24.11.1) does not match the client IP address. If it
does not match, the VLC1012 will disconnect the FTP session immediately.
Firmware and Configuration File Maintenance
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds
297.89Kbytes/sec.
ftp> quit

Figure 25-2 FTP Session Example

Table 25-2 General Commands for GUI-based FTP Clients

Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied to the
server for anonymous access. Anonymous logins will work only if your ISP
or service administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary mode.
Specify the default remote directory (path).
Specify the default local directory (path).
IES-2000/3000 User's Guide
DESCRIPTION
25-3